First Time Usage; Horizontal Alignment; Vertical Alignment - Futech GYRO RED Mode D'emploi

First time usage

•
Remove all protection foile
•
Fully charge the device, only with the supplied charger.
EN
•
Turn the device on (8), pay attention that the device isn't too tilted (maximum
5°). If the device is tilted more then 5°, the laser beam will keep blinking and
the lamp of the manual mode will go on and off.

Horizontal alignment.

•
As soon as the laser beam is leveled, the device will start spinning in the re-
ceive modus, this is the highest spinning speed.
•
You can change the spinning speed by pressing the rotation speed key(9). Pay
attention that the highest rotation mode is necessary for a good detection with
the laser receiver.
• The visibility of the laser beam depends of the concentration of the beam, this
means that the slowest rotation speed is the most visible, and the highest rota-
tion speed is the least visible.
•
It's recommended to put the horizontal line at your work height.
• Important: The choice of the tripod defines in a large way the user friendliness
of the device.
• If the place of work has a light intensity that's too high, (for example when
working outside) it may be needed to use the laser receiver.

Vertical alignment

•
Put the device on the legs in the vertical position, if the device is too tilted
(more then 5°) the laser beam will keep blinking and the lamp of the manual
mode will go on and off.
• As soon as the device is leveled, the laser will start rotating (see horizontale
alignment above).
• The positioning of the vertical line is possible with the keys (14) to relocate the
laser to the left or right.
• If the place of work has a light intensity that's too high, like for example, work-
ing outside, it could be necessary to use the laser receiver.
44 GYRO RED / GYRO GREEN
www.futech-tools.com