Customizing The Equalizer Curve; Adjusting Setup Items - Set - Sony MEX-BT2700 Mode D'emploi

Customizing the equalizer curve

— EQ3
"CUSTOM" of EQ3 allows you to make your
own equalizer settings.
1
Select a source, then press the select
button repeatedly to select "EQ3."
2
Rotate the control dial to select
"CUSTOM."
3
Press the select button repeatedly
until "LOW," "MID" or "HI" appears.
4
Rotate the control dial to adjust the
selected item.
The volume level is adjustable in 1 dB steps,
from –10 dB to +10 dB.
Repeat steps 3 and 4 to adjust the equalizer
curve.
To restore the factory-set equalizer curve,
press and hold the select button before the
setting is complete.
After 5 seconds, the setting is complete and
the display returns to normal play/reception
mode.
Tip
Other equalizer types are also adjustable.
Adjusting setup items — SET
1
Press and hold the select button.
The setup display appears.
2
Press the select button repeatedly
until the desired item appears.
3
Rotate the control dial to select the
setting (example "ON" or "OFF").
4
Press and hold the select button.
The setup is complete and the display returns
to normal play/reception mode.
Note
Displayed items will differ, depending on the source
and setting.
The following items can be set (follow the page
reference for details):
CLOCK-ADJ (Clock Adjust) (page 8)
CT (Clock Time) (page 13, 15)
BEEP
Activates the beep sound: "ON," "OFF."
AUX-A* 1 (AUX Audio)
Activates the AUX source display: "ON,"
20
"OFF" (page 21).
A.OFF
Shuts off automatically after a desired time
when the unit is turned off: "NO," "30S
(seconds)," "30M (minutes)," "60M (minutes)."
SUB/REAR*
1
Switches the audio output: "SUB-OUT"
(subwoofer), "REAR-OUT" (power amplifier).
DEMO (Demonstration)
Activates the demonstration: "ON," "OFF."
DIM (Dimmer)
Changes the display brightness: "ON," "OFF."
A.SCRL (Auto Scroll)
Scrolls long items automatically: "ON," "OFF."
LOCAL (Local Seek Mode)
– "ON": to only tune into stations with stronger
signals.
– "OFF": to tune normal reception.
MONO* 2 (Monaural Mode)
Selects monaural reception mode to improve
poor FM reception: "ON," "OFF."
REG* 2 (Regional) (page 14)
LPF* 3 (Low Pass Filter)
Selects the subwoofer cut-off frequency: "OFF,"
"80Hz," "100Hz," "120Hz," "140Hz," "160Hz."
LPF NORM/REV* 3 (Low Pass Filter Normal/
Reverse)
Selects the phase when the LPF is on: "NORM,"
"REV."
HPF (High Pass Filter)
Selects the front/rear speaker cut-off frequency:
"OFF," "80Hz," "100Hz," "120Hz," "140Hz,"
"160Hz."
LOUD (Loudness)
Reinforces bass and treble for clear sound at low
volume levels: "ON," "OFF."
BTM (page 13)
BT INIT*
1 (page 19)
*1 When the unit is turned off.
*2 When FM is received.
*3 When the audio output is set to "SUB-OUT."