Hatco GLO-RAY GR Serie Manuel D'installation Et D'utilisation page 11

English
3. Secure the conduit-side stand to the unit using the screws
supplied.
4. align the opposite-side stand with the mounting holes at
the other end of the unit and secure the stand to the unit
using the screws supplied.
5. Secure the stands to the mounting surface.
NOTE: The adjustable stands can be raised or lowered by
turning the locking set screw counterclockwise one turn
with an Allen wrench. After loosening the set screw,
raise or lower the unit to the desired height and
retighten the screw. Do not loosen the screw more than
necessary.
NOTE: Two pairs of stands will be needed for mounting dual
units.
Set
Screw
Mounting
Screw
Adjustable
Stand
Tubular Stand mounting
Adjustable Angle Bracket Mounting
mounting a strip heater with adjustable angle brackets
permanently attaches the unit to the underside of a shelf. Units
can be mounted to a flat shelf or a shelf with rolled/flanged
edges. adjustable angle brackets provide the necessary gap
between the unit and a combustible shelf.
CAUTION
To ensure safe and proper operation, refer to the "Minimum
Clearance Requirements" listed in the INSTALLATION
section of this manual.
NOTE: When mounting the unit under a shelf, it is
recommended to use remote-mounted control switches.
Use the optional adjustable angle brackets to mount the unit
below the lowest part of the rolled or flanged edge of the shelf
(a minimum gap of 1" [25 mm] is required between the unit and
the underside of a rolled or flanged shelf to prevent heat
damage to the electrical system of the unit).
Form No. GRm-0115
Non-Adjustable
Stand
Flexible
Conduit
11
Shelf with 3/4" (19 mm)
flanged edge
Adjustable
Angle
Bracket
Flanged Edge Shelf Installation
NOTE: GRN Series units are supplied with matching Designer-
colored angle brackets that provide 1-1/2" (38 mm)
clearance between the unit and an overshelf.
Adjustable Angle Bracket Mounting on Aluminum Models
Use the following procedure to install adjustable brackets on
each end of aluminum housing models (GRa, GRaH, GRaL,
and GRaHL).
1. Position the unit on a flat surface with the heating element
facing down.
2. Remove the two hanger tab screws and hanger tabs.
These items will not be needed.
3. Remove the two upper end plate screws.
4. align the adjustable angle bracket with the end plate
mounting holes on the unit. Secure the angle bracket with
the previously removed end plate screws.
Removed
Hanger Tabs
End Plate
Screws
Adjustable
Angle Bracket
aluminum model adjustable angle Bracket Installation
5. Fasten the angle brackets to the underside of the shelf
using appropriate fasteners (not supplied by Hatco).
NOTE: Two pairs of brackets will be needed for dual units.
Two adjustable
angle brackets
on each end
for dual units.
Dual Unit mounting
INSTALLATION
1" (25 mm)
Gap
Minimum