General Safety Instructions - EUROM EK2K Manuel D'utilisation

Technical data
Type
Supply voltage
Maximum capacity
Settings
Thermostat
Protection class
Dimensions
Weight

General safety instructions

Before using the machine, carefully read this entire instruction manual. Keep this
1.
booklet in a safe place for reference.
Before using your new heater, check it, including cord and plug, for any visible
2.
damage. Do not use a damaged heater, but send it back to your dealer for
replacement.
This heater is exclusively intended for normal household and light commercial
3.
use. Avoid dusty conditions.
This heater in not suitable for use in wet or damp spaces such as bathrooms and
4.
laundry rooms. Do not place the heater in the vicinity of taps, bathtub, shower,
pool, fountains or other sources of moisture. Make sure it cannot fall into water
and prevent water from getting into the heater itself. If, at any time, the heater
does fall into water, unplug it immediately! Do not use a heater that has a damp
interior but have it repaired. Never immerse the heater, cord or plug in water and
never touch it with wet hands. Do not use the appliance if power cord or plug is
wet.
The supply voltage and utility frequency, specified on the machine, need to match
5.
those of the socket that is used. The electrical installation needs to be protected
by a residual current device (max. 30 mAmp). Only connect the heater to an
earthed socket with sufficient capacity: ≥ 10A (EK2K) or ≥ 16A (EK3K)).
Fully extend the cord before plugging in the heater. Make sure it does not come
6.
into contact with any part of the heater and prevent it from heating up any other
way. Do not run the cord underneath carpeting; do not cover it with mats, carpet
strips, or similar and make sure it is not placed in any passageways. Make sure
the cord cannot be stepped on and that no furniture is placed on top of it. Do not
lead the cord around sharp corners and do not roll it up too tightly after use!
If possible, do not use an extension cord, as this poses the risk of overheating
7.
and fire. If the use of an extension cord is unavoidable, then make sure it is an
undamaged, approved extension cord with a minimum permissible power of 2000
Watt/10Amp. (EK2K) or 3000W/16A (EK3K). To prevent overheating, always fully
extend the cord!
To prevent the circuit being overloaded and fuses being blown, make sure no
8.
other appliances are connected to the same socket or wired to the same electrical
circuit as the heater.
English
EK2K
Volt/Hz 230 / 50
Watt 2000
0 - 1000 – 2000
Wat
+
IP21
cm 18,7 x 17,7 x 19,3
kg 2,1
11
EK3K
230 / 50
3000
0 – 1500 - 3000
+
IP21
23,8x23,8x24,8
3,4