Maintenance - AVG ALASKA AVA-304RS Instructions D'installation

MAINTENANCE
SAFETY WARNING: NEVER PUT YOUR HAND INTO AREA HOUSING THE FAN
For optimal operation, clean range hood and filters regularly. Regular care will help preserve the appearance of
the range hood.
CLEANING THE SURFACES
Clean periodically with hot soapy water and clean cotton cloth. Do not use corrosive or abrasive detergent or steel
wool pads, which will scratch and damage the stainless steel finish. For heavier soil, use a liquid degreasing
cleaner. Use a stainless steel cleaner to clean the surfaces of the hood. Avoid getting cleaning solution onto or
into the control panel. Follow directions of the stainless steel cleaner.
CAUTION
USE SOFT TOWEL TO WIPE OFF THE CLEANING SOLUTION, GENTLY RUB OFF ANY STUBBORN SPOTS. USE DRY SOFT TOWEL
TO DRY THE HOOD. ALWAYS SCRUB LIGHTLY WITH CLEAN COTTON CLOTH AND IN THE DIRECTION OF THE GRAIN.
DO NOT ALLOW DEPOSITS TO ACCUMULATE OR REMAIN ON THE HOOD. DO NOT USE ORDINARY STEEL WOOL OR STEEL
BRUSHES. SMALL BITS OF STEEL MAY ADHERE TO THE SURFACE AND CAUSE RUSTING.
DO NOT ALLOW SALT SOLUTIONS, DISINFECTANTS, BLEACHES OR CLEANING COMPOUNDS TO REMAIN IN CONTACT WITH
STAINLESS STEEL FOR EXTENDED PERIODS. MANY OF THESE COMPOUNDS CONTAIN CHEMICALS, WHICH MAY BE
HARMFUL. RINSE WITH WATER AND WIPE DRY WITH A CLEAN CLOTH.
CLEANING THE GREASE FILTER
The filters are intended to filter out residue and grease from cooking and are required to be kept clean. Filters
should be cleaned after every 30 hours of use (or once a month, depending on use). Remove and clean by hand
in soapy water or in the dishwasher. Dry filters and re‐install. If cleaning the filters in the dishwasher, use a non‐
phosphate detergent. The use of detergent with phosphate may cause discoloration of the filters, but will not
affect their performance. This discoloration is not covered by the warranty.
REPLACING THE FILTERS
If filters wear out due to prolonged use, please contact your service/parts provider for replacement filters.
NOTE:
ALSO REPLACE DAMAGED FILTER THAT HAS PUNCTURED OR BROKEN MESH, BENT OR BROKEN FRAME.
CLEANING THE STAINLESS STEEL SURFACES
Regularly wash surfaces with dry cloth or clean cloth soaked in warm water and mild soap or liquid dish detergent.
Always clean following the grain. Always rinse thoroughly with clear water (2‐3 times) and wipe dry completely.
Specially designed stainless steel cleaners can also be used.
REPLACING THE LED LIGHT BULBS
Cut the power supply by turning the hood off. Wait for the LED lamps to cool. To prevent damage or to avoid
reducing the life of the new bulb, do not touch the bulb with your bare fingers. Replace the bulb by manipulating
with a tissue paper or cotton gloves.
If the new lights do not work, ensure that each lamp is properly inserted into its socket before requesting the
intervention of a service agent.
32