Connecting The Power Supply; Inserting/Replacing Battery - KERN KME-TM Mode D'emploi

2.4 Closing the terminal
Closing KME-TM
➜ Mount the cover and tighten the 4 screws.
Closing KMN-TM
➜ Mount the cover and press on the bottom housing until the spring clips engage.

2.5 Connecting the power supply

CAUTION!
Before connecting the weighing terminal to the mains, check whether the volt-
age value printed on the rating plate corresponds with the local mains volt-
age.
▲ Do not at all connect the weighing terminal if the voltage value printed
➜ Plug the mains plug into the socket.
After connection, the weighing terminal performs a self-test.
When the zero display appears, the weighing terminal is ready for operation.
➜ Adjust the weighing platform in order to obtain the highest possible precision (see
Service Manual).

2.6 Inserting/replacing battery

NiMH rechargeable battery
1. Open the battery case on the bottom of the terminal.
2. Undo the old rechargeable battery from the velcro strip, and disconnect plug if necessary.
3. Connect the (new) rechargeable battery to the terminal, and insert the rechargeable battery
in the battery case.
4. Close the battery case.
on the rating plate is different to the local mains voltage.
7