Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Attach Adhesive Seal
1. Cut the adhesive seal to the width of the lower window sash.
2. Remove the backing from the seal and attach the seal to the
bottom of the lower window sash.
Install L Brackets
1. Measure the width of the window opening and mark the
center line on the outside windowsill.
A
B
A. Width of window opening
B. Center line
WARNING
Excessive Weight Hazard
Use two or more people to move and install
air conditioner.
Failure to do so can result in back or other injury.
NOTES:
Handle air conditioner gently.
Be sure your air conditioner does not fall out of the opening
during installation or removal.
The place where the power cord exits the air conditioner
should be no more than 6 ft (182.9 cm) from a grounded
outlet.
Do not block the louvers in the front panel.
Do not block the louvers on the outside of the air conditioner.
1. Center air conditioner in window. Be sure the bottom
channels on the air conditioner drop into the notches of the L
brackets. Lower the window sash behind the top channel to
hold cabinet in place.
Prepare Window for Installation
2. Use ¹⁄₈" drill bit to drill a starter hole for each of the two L
brackets located 8¹⁄₈" from the center line.
3. Using ³⁄₄" screws, install the L brackets on the outside
windowsill. The short side of the brackets should face toward
the outside.
Position the Air Conditioner
NOTE: Your model may differ from the one shown.
B C
A
F
E
E
A. Outside windowsill
D. Center line
³⁄₄
B.
" screw
E. 7
C. Inside windowsill
F. Short side of bracket
A
A. Side curtain against window channel
B. Window sash behind top channel
C. Bottom channel in bracket notches
D
B
¹⁄₂
"
B
C
7
Publicité
Table des Matières
