emerio MS-125001 Mode D'emploi page 9

OVERVIEW
Fig. A
1. Rotary knob and stop plate
Set slicing width (0 to 15 mm).
2. Start lock-out
Press and hold to switch on. Prevents the appliance from being unintentionally switched on.
3. ON button
Instantaneous setting
4. Blade
5. Carriage
Guide the food which is to be sliced against the blade.
6. Slide
Pos. 1 (slide on right)
= Lock the carriage in the end position
Pos. 2 (slide in centre)
= Carriage movable
Pos. 3 (slide on left)
= Remove carriage
7. Base
Supports the carriage.
8. "Sausage end" holder
Cuts residual pieces safely.
9. Cord store
OPERATION
Before using the appliance for the first time, clean thoroughly.
Preparation:
Fig. A

Place the appliance on a smooth, clean surface.

Pull out cable from the cord store 9 to the required length:
1. Remove cable from the two clamping slots.
2. Pull out/push in cable past the cover to the required length.
3. Re-attach cable end.

Attach carriage 5 and "sausage end" holder 8.

Use the rotary knob 1 to set the required cutting width.

Insert the plug.
Switching the appliance ON/OFF:
Risk of injury from sharp blade!
Blade is very sharp. Keep hands clear of the blade. After switching off, the drive continues for a short time. After
work, set cutting width to 0.
Fig. B

1. Press the switch-on safety device and hold down.
2. Simultaneously press ON button until the power tool starts running.
3. Release the switch-on safety device again.

To stop the appliance, release the ON button.
- 8 -