Intended Use; Electrical Connection - Franke SMART FMO 45 GN 86 WH Manuel D'installation Et Mode D'emploi

INTENDED USE

This product has been designed for domestic
use. Commercial use is not permitted. This
appliance may only be used for cooking
purposes. It shall not be used for other
purposes like heating a room. This appliance
shall not be used to heat plates under the grill,
drying clothes or towels by hanging them on
the handle or for heating purposes.
The manufacturer assumes no responsibility
for any damage due to misuse or mishandling.
Oven part of the unit may be used for thawing,
roasting, and grilling food.
Operational life of the product you have
purchased is 10 years. This is the period
for which the spare parts required for
the operation of this product as defined
is provided by the manufacturer.

Electrical Connection

This oven must be installed and connected
correctly according to manufacturer
instructions and by an authorized service.
Z Z
Appliance must be installed in an oven
enclosure providing proper ventilation.
Z Z
Electrical connections of the appliance
must be made only via sockets having earth
system furnished in compliance with rules.
Contact an authorized electrician if there
is no socket complying with the earthed
system at where appliance will be placed.
Manufacturing company is by no means
responsible for damage resulting from
connection of non-earthed sockets
to appliance.
Z Z
Plug of your oven must be earthed; ensure
that socket for the plug is earthed. Plug
must be located in a place that can
be accessed after installation.
FMO 45 GN 81 / FMO 45 GN 86
Your oven has been manufactured as
220-240 V 50/60 Hz. AC power supply
compliant and requires a 16 Amp fuse.
if your power network is different that these
indicated values, refer to an electrician or your
authorized service.
When you need to replace the electrical fuse,
please ensure that electrical connection
is made as follows:
–
–
–
Z Z
Z Z
Z Z
– 7 –
Phase (to live terminal) brown cable
Blue cable to neutral terminal
Yellow-green cable to earth terminal
Oven disconnecting switches must be
in an accessible place for final user while
oven is in its place.
Power supply cable (plug in cable) mustn't
touch hot parts of the appliance.
If supply cord (plug in cable) is damaged,
this cord must be replaced by the importer
or its service centre or equally competent
personnel to prevent a hazardous situation.
EN