Rack Positions - Franke SMART FMO 45 GN 86 WH Manuel D'installation Et Mode D'emploi

EN
Cleaning Oven Glass
X Z
Lift by pressing on plastic latches on
left and right side as shown in figure
8 and pulling the profile toward yourself
as in figure 9.
„ „
Glass is released after profile
is removed as shown in figure 10.
X Z
Remove the released glass by pulling
toward yourself carefully. Outer glass
is fixed to oven door profile. You can
perform glass cleaning easily after glasses
are released. You can mount glasses back
by performing the operations reversely
after cleaning and maintenance are
completed.
X Z
Ensure that profile is seated properly
in place.

Rack Positions

It is important to place the wire grill into the
oven properly. Do not allow wire rack to touch
rear wall of the oven. Rack positions are shown
in the next figure. You may place a deep tray
or a standard tray in the lower and upper wire
racks.
FMO 45 GN 81 / FMO 45 GN 86
Installing and removing wire racks
X Z
X Z
Replacing Oven Lamp
WARNING: to avoid electric shock, ensure that
the appliance circuit is open before changing
the lamp (having circuit open means
power is off).
X Z
X Z
Fig. 8
X Z
X Z
Fig. 9
Fig. 10
– 18 –
Rack 4
4
Rack 3
3
2
Rack 2
1
Rack 1
To remove wire racks, press the clips
shown with arrows in the figure, first
remove the lower, and than the upper side
from installation location.
To install wire racks; reverse the procedure
for removing wire rack.
First disconnect the power of appliance
and ensure that appliance is cold.
Remove the glass protection by turning
as indicated in the figure on the left side.
If you have difficulty in turning, then using
plastic gloves will help you in turning.
Then remove the lamp by turning, install
the new lamp with same specifications.
Reinstall glass protection, plug the power
cable of appliance into electrical socket
and complete replacement. Now you can
use your oven.