Cleaning; Fault/Remedy - ADE WS 1604 Mode D'emploi

Cleaning

Cleaning
1. Pull the mains adaptor plug out of the base station.
2. As necessary, wipe the base station and the outdoor sensor clean with a lightly-
dampened cloth.
3. Dry the device completely before you reconnect it with the mains adaptor.

Fault/Remedy

Fault
The DCF77 signal for the time cannot be
received.
The temperature information of the sensor
seems too high.
Instead of showing the measured values
for temperature or humidity, the display
shows H.HH or LL.L.
The display shows "--.-" instead of the
outdoor temperature.
The indicator is illegible, the function is
unclear, or the values are obviously false.
The base station is not receiving signals
from the wireless sensor.
The time differs by exactly one, two, three,
etc. hours.
50
Possible Cause
‚ Check the chosen location.
‚ Start the signal reception manually, if
necessary.
‚ Adjust the time manually.
‚ Check whether the sensor has been
exposed to direct sunlight.
‚ The values lie above or below the
measurement range.
‚ Press and hold the CH button to
manually start signal reception to the
outdoor sensor. In addition, you can
press the TX button in the battery
compartment of the wireless sensor
to transmit data faster to the base
station.
‚ Select an available outdoor sensor via
the CH button.
‚ Disconnect the base station for a few
moments from the current supply.
‚ Ensure that no electrical sources of
interference are located in the vicinity
of the wireless sensor or of the base
station.
‚ Check the batteries in the sensor.
‚ Move the base station closer to the
sensor, or vice versa.
‚ You have probably set an incorrect
time zone.
Weather station with radio alarm clock WS 1604