Reset; Cleaning - ADE WS 1914 Mode D'emploi

Reset

If obviously false values are being shown on the display of
the base station, you should reset the base station to the
delivery state.
1. Insert a thin object, e.g. an unfolded paperclip, into the
RESET opening on the rear side of the base station.
2. Press with a little force against the resistance.
After a short time, all indicators on the display will
fade in for a brief moment. Furthermore, the display is
briefly lit up and a beep sounds.
After a few seconds, the indicators start to blink and the
data from the outdoor sensor is retrieved.
Pay attention to the values shown on the display.
To speed up the data exchange with the base
station, hold down the + button on the base
station until the OUTDOOR TEMPERATURE data is
deleted. Shortly thereafter, the newly loaded data
is displayed.

Cleaning

1. During operation via the mains: Pull the mains adaptor
plug out of the base station.
2. As necessary, wipe the base station and the outdoor
sensor clean with a lightly-dampened cloth.
3. Dry the device completely before you reconnect it with
the mains adaptor.
Weather Station with Wireless Outdoor Sensor WS 1914
71