Hendi 860502 Mode D'emploi page 4

• Never use accessories other than those recommended by the manufacturer. Failure to do
so could pose a safety risk to the user and could damage the appliance. Only use original
parts and accessories.
• This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge.
• This appliance must not be used by children under any circumstances.
• Keep the appliance and its cord out of reach of children.
• Always disconnect the appliance from the mains if it is left unattended or is not in use,
and before assembly, disassembly or cleaning.
• Never leave the appliance unattended during use.
Hendi Soup kettle Eco 860502
Hendi Soup kettle 860083
* Indoor use, ambient temperature of 25 °C, lid closed and water pan filled to at least
the minimum water level mark.
Preparation and how to use
• Check to make sure the appliance is undamaged.
EN
In case of any damage, contact your supplier im-
mediately and do NOT use the appliance.
• Remove all the packing material and protection
film (if applicable).
• Clean the appliance with luke-warm water and
a soft cloth.
Important
• Always ensure that there is sufficient water in the inner pot. Check this regularly, also during use.
Maintenance advice
• Always remove the plug from the socket before
cleaning.
• If used intensively, regularly remove lime scale
from the bottom of the water tank
• Never immerse the appliance in water or any oth-
er cleaning fluid
• Clean the appliance with a damp cloth
4
This soup kettle saves up to 30% on energy costs compared to traditional
soup kettles (like Hendi 860083)*
Consumption per hour
0,125 kWh
0,160 kWh
• Place the appliance on a level and steady surface,
unless mentioned otherwise.
• Make sure there is enough clearance around the
appliance for ventilation purposes.
• Position the appliance in such a way that the plug
is accessible at all times.
• Never use aggressive, corrosive cleaning agents
or abrasives. Do not use any sharp or pointed ob-
jects. Do not use petrol or solvents! Clean with
a damp cloth and detergent if necessary. Do not
use abrasive materials.
• Avoid water contact with the electrical compo-
nents as much as possible.