Control Panel - PerkinElmer OMNI Bead Ruptor 96 Manuel D'utilisation

1.
2.
3.
• RUN Signal light (green) - lit when the Bead Ruptor
• TIME Signal light (yellow) - lit when the Bead Ruptor
selection is active.
• FREQUENCY Signal light (yellow) - lit when the Bead Ruptor
frequency selection is active. Frequency is defined as number of wave cycles per
second (1/s). Measured in Hz.
• CONTROL KNOB (rotate / push) - rotate right (+) Or left (-) to change the Time
or Frequency setting values. Push the Control Knob to switch between Time and
Frequency settings.
• START/STOP button - press to start or stop the cycle.
WARNING: Only start the Bead Ruptor
position. The display will read "LID" if the lid is open when attempting to start.
Always start and stop the Bead Ruptor

Control Panel

RUN TIME FREQ
1. Run signal light
2. Time signal light
3. Display Screen
4. Frequency signal light
5. Control Knob
6. Start/Stop button
96 Homogenizer is running.
TM
96 Homogenizer timer
TM
96 Homogenizer with the lid in the closed
TM
96 with the Start/Stop button.
TM
START
STOP
96 Homogenizer
TM
4.
5.
6.