Before Fi Rst Use; Charging The Storage Battery - Maxx-world Z 05130 Mode D'emploi

Hold this button down to defl ate the air chamber (5) and decrease the pillow's
height.
Set the sensitivity of the noise sensor. After you have pushed the Mode button,
turn the knob to + in order to increase the sensor sensitivity (for light snoring) or
to - to reduce it (for loud snoring).
Before fi rst use
ATTENTION!
❐ Keep children away from the packaging. There is, among other things, a danger of suffocation!
❐ Only use the enclosed mains adapter for the power supply.
1. Unpack all parts and make sure that the product contents are complete (see "Product con-
tents") and check for any damages from transport. If you identify damages to the compo-
nents, do not use them (!), instead contact our customer service centre.
2. Recharge the storage battery (see chapter "Charging the storage battery").

Charging the storage battery

ATTENTION!
❐ Make sure that the device is deactivated before you connect it to the charger!
❐ Completely charge the storage battery before fi rst use for maximum charge.
1. First connect the mains adapter to the connector jack (3) of the device and then to a
properly installed, easily accessible socket.
2. Let the storage battery of the device charge for approximately 8 hours in order to reach the
maximum charge. The green power light will illuminate as long as the device is connected to
the power supply.
3. Disconnect the mains adapter from the power supply fi rst and then from the device.
15