Device Overview; Control Panel - Maxx-world Z 05130 Mode D'emploi

Device overview

6
1 Main switch
2 Red power LED: illuminates when the device is turned on.
3 Connector jack for the mains adapter
4 Charge control light: illuminates in green when the rechargeable battery is charged.
5 Air chamber

6 Control panel

Remove the slipcover, at least in part, from the pillow to reveal the control panel, main
switch and connector jack.
Control panel
You can select the following functions on the control panel. As long as one of the functions has
been activated, the corresponding LED will illuminate.
On/Off: If the main switch (1) is used to activate the device, the On/Off button
can be used. This will enable you to activate the other
Mode: Pushing the button once will activate the noise sensor (the LED will blink),
which will automatically engage after 30 minutes and direct the snoring noises to
the device. If you would like to activate the noise sensor immediately, push the but-
ton again (the LED will illuminate permanently). Pushing the Mode button a third
time will turn off the noise sensor (the LED will turn off).
Hold this button down to infl ate the air chamber (5) and increase the pillow's
height.
1
5
14
2
3
4
functions.