First Use; Setting The Water Softener - Pelgrim GVW592RVS Notice D'utilisation

Factory setting: audible signals activated
It is possible to deactivate the audible
signals.
Deactivation/activation of the audible
signals
1. Press the on/off button. The appliance
must be in setting mode.
2. Press and keep pressed the programme
selection/cancel button until programme
light A flashes and programme light B
comes on with a fixed light.
3. Press programme selection/cancel but-
ton again. The programme light A comes
on with a fixed light and programme light
B starts flashing. Wait until programme
light A goes off. The programme light B
goes on flashing and the end of pro-
gramme indicator light is on with a fixed

First use

Before using your dishwasher for the first
time:
• Ensure that the electrical and water con-
nections comply with the installation in-
structions
• Remove all packaging from inside the ap-
pliance
• Set the water softener level

Setting the water softener

The dishwasher is equipped with a water
softener designed to remove minerals and
salts from the water supply, which would
have a detrimental or adverse effect on the
operation of the appliance.
The higher the content of these minerals and
salts, the harder your water is. Water hard-
ness is measured in equivalent scales, Ger-
man degrees (dH°), French degrees (°TH)
and mmol/l (millimol per litre - international
unit for the hardness of water).
Water hardness
°dH
51 - 70 91 - 125
43 - 50
37 - 42
29 - 36
23 - 28
°TH mmol/l
9,1 - 12,5
76 - 90 7,6 - 9,0
65 - 75 6,5 - 7,5
51 - 64 5,1 - 6,4
40 - 50 4,0 - 5,0
light. This indicates that you have activa-
ted the function for deactivating/activat-
ing the audible signals. The fixed light of
the end of programme indicator light
means that the audible signals are acti-
vated.
4. To deactivate the audible signals, press
the programme selection/cancel button
again. The end of programme indicator
light goes off indicating that the audible
signals are deactivated.
5. To memorize the operation, switch off the
appliance by pressing the on/off button.
• To activate again the audible signals sim-
ply follow the above operations until the
end of programme indicator light comes
on.
• Pour 1 litre of water into the salt container
and then fill with dishwasher salt
• Fill the rinse aid dispenser
If you want to use combi detergent
tablets such as: '3 in 1', '4 in 1', '5 in
1' etc. follow the instructions given
in 'Use of detergent'.
The softener should be adjusted according
to the hardness of the water in your area.
Your local Water Authority can advise you on
the hardness of the water in your area.
The water softener must be set in two
ways: manually, using the water hard-
ness dial and electronically.
Adjusting the water hardness setting
manually
2
2
2
2
2
Use of
electronically
level 10
level 9
level 8
level 7
level 6
65
salt
yes
yes
yes
yes
yes