Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
The first cycle
(see fig. 2)
Turn the tap on fully.
Open the door so that you can access the
control knobs.
Switch on the appliance with button
The indicator lamps
and
are now
on (if the indicator lamp
does not come
on, keep button
-pressed).
START
Select a programme with the knobs 1-5.
See table on page 25.
Press
until the indicator light
goes
START
out.
Close the door. The programme will begin
after a short while.
End of programme
The indicator lamp
comes on.
Open the door so that you can access the
control knobs. Switch the appliance off
.
with the button
. The indicator lamps go
out.
If you have selected a programme with a
drying cycle, you can empty the machine
after about 30 minutes. Keep the door
closed for that period.
Unload the dishwasher. Be careful:
– The kitchenware could be hot.
– Unload the lower basket first. If you
unload the upper basket first, drops of
water could fall on the kitchenware in the
lower basket.
To interrupt a programme which is running,
open the door and then select the "pre-rinse
programme"(
+
). Next, close the door.
START
After a few minutes, the dishwasher will move
to the setting "end of cycle" (
). You can
now take the tableware out of the dishwasher.
Interruption in a running program
Open the door carefully, so that there is no
water squirting out of the machine.
When the water is already heated up, close
the door completely only after some
minutes resting in leaned position. Add
eventualle extra loading. Caution:
– the tablewear inside can be very hot.
Trouble shooting
If the machine does not work properly, first
check if you can solve the problem yourself
with the help of the accompanying table. Often
the cause of the problem is something very
small.
The programme does not start
cause
remedy
The plug is not in the
Put the plug in the socket.
socket.
The door is not closed
Close the door.
properly.
Defective fuse in
Check the fuse-box.
the fuse-box.
No water in the appliance
cause
remedy
The water tap is not on.
Turn the water tap on.
There is a kink in
Make sure the water inlet
the water inlet hose.
is hanging freely.
There is another cap
Remove the cap.
located in the discharge
hose, or in the discharge-
hose connection on the
siphon.
Programme interrupted
cause
remedy
The water tap is not on
Turn the water tap on fully.
fully.
The tap filter is dirty.
Clean the tap filter.
The trap cap of the siphon Place the trap cap in the
is not in place.
siphon.
The kitchenware is not clean
cause
remedy
Wrong programme.
Select the correct washing
programme.
Spray arms blocked.
Make sure that the spray
arms can rotate freely.
Check that the kitchenware
has been loaded properly.
Clean the filters.
Incorrect amount of
Adjust the amount of
detergent.
detergent. Check that there
is still some salt in the salt
container. Make sure that
the salt container is
correctly adjusted to the
hardness of the water.
Kitchenware not dry and not gleaming
cause
remedy
Wrong detergent used.
Use a good detergent.
Incorrect amount of
Use more detergent.
detergent.
Whitish spots or streaks on the kitchenware
cause
remedy
Incorrect amount of
Use less rinse-aid.
rinse-aid.
Dried drops of water on the kitchenware
cause
remedy
Incorrect amount of
Use more rinse-aid.
rinse-aid.
Publicité
Chapitres
Table des Matières
