Stryker Stair-PRO 6250 Manuel D'utilisation Et D'entretien page 40

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 45
English
TRACK BELT REPLACEMENT (FOR MODEL 6252) - CONTINUED
7.
Thread the new belts through the wheel support plate.
8.
Replace the track rollers, washers, hex head cap screws
and nuts.
9.
Use two 7/16" wrenches to apply the desired tension to
each belt and tighten securely.
Note: To check the tension, pull up on the center of the belt
until it is taut. The gap between the belt and the track frame
should measure between 3/8" and 1" as shown in Figure 54.
10. Spin the belts to verify they roll freely.
Return To Table of Contents
1-38
Service Information
Figure 53 - Use wrenches to apply tension to the
6250-001-161 REV D
Figure 52 - Attach the new track belt
belts
Figure 54 - Proper belt tension
www.stryker.com

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Stair-pro 6251Stair-pro 6252

Table des Matières