Track Belt Replacement (For Model 6252) - Stryker Stair-PRO 6250 Manuel D'utilisation Et D'entretien

English

TRACK BELT REPLACEMENT (FOR MODEL 6252)

Tools Required:
• (2) 7/16" Wrenches
• 3/16" Hex Key
• 1/2" Wrench
• 5/32" Hex Key
Procedure:
1. Using a 7/16" wrench and a 3/16" hex key, remove
the socket head cap screw, nut and washer from the
track support bracket on only one side of the chair.
2. Turn the chair upside down so it is resting on the
seat frame and back frame as shown in Figure 47.
3. Using a 1/2" wrench and a 3/16" hex key, remove the
button head cap screw, nut, spacers and wheel from the
frame on the same side as the parts removed in step one.
Return To Table of Contents
1-36
Service Information
Figure 46 - Remove the screw, nut and washer
6250-001-161 REV D
Figure 47 - Turn the chair upside down
Figure 48 - Remove the wheel assembly
www.stryker.com