Using The Optional Head Support (Model 6252 Only); Top View - Stryker Stair-PRO 6250 Manuel D'utilisation Et D'entretien

USING THE OPTIONAL HEAD SUPPORT (MODEL 6252 ONLY)

Upper Control Handle
WARNING
The Stair-PRO Stair Chair is not recommended for use with suspected cervical, spinal, or fracture injuries.
®
Before using the optional head support, the upper control handle must be extended. First, pull the red upper control
handle release cable with one hand. Then, pull up on the handle with the other hand. Release the cable and verify the
handle is securely locked into one of the two available positions.
To attach the optional head support to the extendable upper control handle:
1. Wrap the loose ends of the strap around the vertical portions of the handle, then feed them through the plastic
loops.
2. Pull tight, and secure the strap to itself.
3. Adjust the height by loosening the strap, moving it to the desired location, and tightening it again.
To support the patient's head, position at the base of the head. For unconscious, or semiconscious patients, secure
the head using the other two parts of the strap. Wrap around the patient's head, and overlap the straps to the desired
tightness to secure. When not in use, these straps can be wrapped back around the handle and attached to the back
of the support.
www.stryker.com
Operation Guide
TOP VIEW
Slide Ring
Figures 41-43 - Attaching and using the head support
6250-001-161 REV D
Head Support
Return To Table of Contents
English
1-27