Operating The Wheel Locks - Stryker Stair-PRO 6250 Manuel D'utilisation Et D'entretien

English

OPERATING THE WHEEL LOCKS

To activate the wheel locks:
1. Press down on the pedals (A) until they stop.
2. To release the wheel locks, depress the upper face of the pedal with your foot or lift up with your toe under the
pedal. The upper portion of the pedal will rest against the chair frame when the wheel lock is released.
WARNING
• Only use wheel locks during patient transfer or without a patient on the chair. Tipping could occur if the chair is
moved while the wheel locks are applied, resulting in injury to the patient or operator and/or damage to the chair.
• Wheel locks are only intended to help prevent the empty chair from rolling while unattended, and to aid in patient
transfer. A wheel lock may not provide sufficient resistance on all surfaces or under loads.
• Never leave a patient unattended on the chair or injury could result. Hold the chair securely while a patient is on
the chair.
• Never use a wheel lock on a chair with excessively worn wheels. Using a wheel lock on a wheel with less than a
5" diameter (Model 6252) or a 6" diameter (Models 6250/6251) could compromise the holding ability of the wheel
lock, possibly resulting in injury to the patient or operator and/or damage to the chair or other equipment.
Return To Table of Contents
1-24
Operation Guide
A
A
Figure 37 - Wheel Locks
(6250 Shown)
6250-001-161 REV D www.stryker.com