Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
VINYL SEAT REPLACEMENT
Tools Required:
• None
Figure 44 - Seat section of vinyl seat
Procedure:
1.
Place the seat section on the frame, wrap it around the seat tube and fit the slots in the seat section over the clips
on the underside of the seat tube. Be sure the "shiny" side of the seat is on the inside.
2.
Tip the chair on its back to allow access to the bottom of the seat tube.
3.
Insert both ends of the front strap through the loops in the seat section. Thread the end of the strap through the
buckle and pull it tight.
4.
Thread the end of the back strap through the buckle and pull it tight.
5.
Tip the chair back up on its wheels.
6.
Wrap the back section around the back tube.
7.
Insert both ends of the top strap through the loops in the back section. Thread the end of the strap through the
buckle and pull it tight.
8.
Thread the end of the bottom strap through the buckle and pull it tight.
www.stryker.com
Service Information
6250-001-161 REV D
Figure 45 - Back section of vinyl seat
Return To Table of Contents
English
1-35
Publicité
Chapitres
Table des Matières
