GUIDANCE AND MANUFACTURER'S DECLARATION
The Free Action is intended for use in the electromagnetic environment speci ed below. The customer or the user of
the Free Action should assure that it is used in such an environment.
IMMUNITY
IEC 60601
TEST
TEST LEVEL
Vrms
Conducted RF IEC
- -
kHz to
MHz
V/m
Radiated RF IEC
- -
MHz to . GHz
NOTE 1 At 80 MHz and 800 MHz, the higher frequency range applies.
Electromagnetic propagation is a ected by absorption and re ection from structures, objects and people.
a. Field strengths from xed transmitters, such as base stations for radio (cellular/cordless) telephones and land mobile radios, amateur radio, AM and
FM radio broadcast and TV broadcast cannot be predicted theoretically with accuracy. To assess the electromagnetic environment due to xed RF
transmitters, an electromagnetic site survey should be considered. If the measured eld strength in the location in which the Free Action is used exceeds
the applicable RF compliance level above, the Free Action should be observed to verify normal operation. If abnormal performance is observed, additional
measures may be necessary, such as re-orienting or relocating the Free Action.
b. Over the frequency range 150 kHz to 80 MHz, eld strengths should be less than 3 V/m.
RECOMMENDED SEPARATION DISTANCES BETWEEN PORTABLE AND MOBILE RF
COMMUNICATIONS EQUIPMENT AND THE FREE ACTION
The Free Action is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled. The
customer or the user of the Free Action can help prevent electromagnetic interference by maintaining a minimum distance
between portable and mobile RF communications equipment (transmitters) and the Free Action as recommended below,
according to the maximum output power of the communications equipment.
RATED MAXIMUM OUTPUT
POWER OF TRANSMITTER
150 KHZ TO 80 MHZ
W
d = 1.17
0.01
0.1
1
10
100
For transmitters rated at a maximum output power not listed above, the recommended separation distance d in metres (m) can be estimated using the
equation applicable to the frequency of the transmitter, where P is the maximum output power rating of the transmitter in watts (W) according to the
NOTE - At
MHz and
Electromagnetic propagation is a ected by absorption and re ection from structures, objects and people.
ELECTROMAGNETIC IMMUNITY
COMPLIANCE
ELECTROMAGNETIC ENVIRONMENT GUIDANCE
LEVEL
Portable and mobile RF communications equipment should be used no
closer to any part of the Free Action, including cables, than the recommended
separation distance calculated from the equation applicable to the frequency
Recommended separation distance
V
d = .
where P is the maximum output power rating of the transmitter in watts
(W) according to the transmitter manufacturer and d is the recommended
separation Distance in metres (m).
Field strengths from xed RF transmitters, as determined by an
electromagnetic site survey,a should be less than the compliance level in each
Interference may occur in the vicinity of equipment marked with
V/m
NOTE 2 These guidelines may not apply in all situations.
SEPARATION DISTANCE ACCORDING TO FREQUENCY OF TRANSMITTER M
80 MHZ TO 800 MHZ
d = 1.17
0.12
0.12
0.37
0.37
1.17
1.17
3.69
3.69
11.67
11.67
transmitter manufacturer.
MHz, the separation distance for the higher frequency range applies.
NOTE - These guidelines may not apply in all situations.
of the transmitter.
d = .
MHz to
MHz
d = .
MHz to . GHz
frequency range.b
the following symbol:
800 MHZ TO 2.5 GHZ
d = 2.33
0.23
0.74
2.33
7.38
23.33
- 65 -