Table des Matières
Publicité
The Free Action is intended for use in the electromagnetic environment speci ed below. The customer or the user of
the Free Action should assure that it is used in such an environment.
EMISSIONS
RF emissions
CISPR
RF emissions
CISPR
Harmonic emissions
IEC
- -
Voltage uctuations/ icker
emissions
IEC
- -
GUIDANCE AND MANUFACTURER'S DECLARATION
The Free Action is intended for use in the electromagnetic environment speci ed below. The customer or the user of
the Free Action should assure that it is used in such an environment.
IMMUNITY
IEC 60601 TEST LEVEL
TEST
Electrostatic
± kV contact
discharge (ESD)
± kV air
IEC
- -
± kV for power supply lines
and dc lines
Electrical fast
transient/burst
IEC
- -
± kV for input/output lines
± kV line(s) and neutral
Surge
IEC
- -
± kV line(s) to earth
< % U
(> % dip in U
T
for , cycle
Voltage
dips, short
% U
(
T
interruptions
for cycles
and voltage
variations
% U
( % dip in U
T
on power supply
for
input lines
IEC
- -
< % U
(> % dip in U
T
Power frequency
( /
Hz)
magnetic eld
IEC
- -
- 64 -
GUIDANCE AND MANUFACTURER'S DECLARATION
ELECTROMAGNETIC EMISSIONS
COMPLIANCE
ELECTROMAGNETIC ENVIRONMENT GUIDANCE
The Free Action uses RF energy only for its internal function. Therefore, its RF
Group
emissions are very low and are not likely to cause any interference in nearby
Class B
Conform
The Free Action is suitable for use in all establishments, including domestic
Class A
establishments and those directly connected to the public low-voltage power
supply network that supplies buildings used for domestic purposes.
Conform
ELECTROMAGNETIC IMMUNITY
COMPLIANCE LEVEL
± kV contact
± kV air
± kV for power supply
lines
Not applicable for input/
output lines
± kV line(s) and neutral
N/A(§ . EN
- - )
< % U
)
(> % dip in U
T
T
for , cycle
% dip in U
)
% U
(
% dip in U
T
T
for cycles
)
% U
( % dip in U
T
T
cycles
for
cycles
)
< % U
(> % dip in U
T
T
for s
for s
A/m
A/m
NOTE - U
is the a.c. mains voltage prior to application of the test level
T
electronic equipment.
ELECTROMAGNETIC
ENVIRONMENT GUIDANCE
Floors should be wood, concrete or ceramic tile.
If oors are covered with synthetic material, the
relative humidity should be at least
Mains power quality should be that of a typical
commercial or hospital environment.
)
T
Mains power quality should be that of a typical
)
T
commercial or hospital environment. If a dips or an
interruption of mains power occurs, the current of
the Free Action may be dropped o from normal
)
T
level, it may be necessary to use uninterruptible
power supply or a battery.
)
T
Power frequency magnetic elds should be at
levels characteristic of a typical location in a typical
commercial or hospital environment.
%.
Publicité
Table des Matières
