Mounting Of Handle - Dolmar MS-246.4 U Instructions D'emploi D'origine

MOUNTING OF HANDLE

CAUTION: Before doing any work on the Petrol Brushcutter, always stop the
engine and pull the spark plug connector off the spark plug.
Always wear protective gloves!
CAUTION: Start the Petrol Brushcutter only after having assembled it
completely.
For machines with bike handle models
– Loosen knob (1).
– Place handle (4) between handle clamp (2) and handle holder (3).
– Adjust handle (4) to an angle that provides a comfortable working position
and then secure by firmly hand-tightening knob (1).
CAUTION: Do not forget to mount spring (5).
For machines with loop handle
– Fix a barrier (6) to the left side of the machine together with the handle for
operator protection.
– Make sure that the grip/barrier assembly is fitted between the spacer and the
arrow mark.
WARNING: Do not remove or shrink the spacer. The spacer keeps a certain
distance between both hands. Setting the grip/barrier assembly
close to the other grip beyond the length of the spacer may cause
loss of control and serious personal injury.
Note: In some countries the handle may be non-barrier type.
Arrow mark
(6)
10
（1）
（2）
（4）
（3）
（5）
Engine
Engine
(6)
Engine