Timer / Settings
If the electrical power supply to your Drawer Microwave
should be interrupted, the display will intermittently show:
ENJOY YOUR MICROWAVE TOUCH CLEAR after the power
is reinstated. If this occurs, the SETTINGS option you input
will be erased. Simply touch STOP/CLEAR pad and reset.
Timer
1. Touch TIMER/SETTINGS pad 3 times.
x 3
2. Enter time.
3. Touch START/+30 SEC pad.
To cancel timer, touch STOP/CLEAR.
Audible Signal Setting
At the end of timed cook, by default, beeps will sound. The
audible signal can be disabled if you prefer quiet operation.
To Disable Sound
1. Touch TIMER/SETTINGS pad 4 times.
x 4
2. Touch START/+30 SEC pad. The display
shows: SOUND OFF.
To Restore Sound
1. Touch TIMER/SETTINGS pad 4 times.
x 4
2. Touch START/+30 SEC pad. The display
shows: SOUND ON.
End Of Cooking Reminder
At end of timed cooking, by default, the microwave will
signal every 10 seconds for the first minute; then every 3
minutes until STOP/CLEAR pad is touched, up to one hour.
To Disable Reminder
1. Touch TIMER/SETTINGS pad 5 times.
x 5
2. Touch START/+30 SEC pad. The display
shows: REMIND SIGNAL OFF.
To Restore Reminder Signal
1. Touch TIMER/SETTINGS pad 5 times.
x 5
2. Touch START/+30 SEC pad. The display
shows: REMIND SIGNAL ON.
6 - OTHER FEATURES
Auto start
If you wish to program the Drawer Microwave to begin
cooking automatically at a designated time of day, follow
this procedure.
x 6 1. Touch TIMER/SETTINGS pad 6 times.
2. Touch START/+30 SEC pad.
3. Enter start time.
4. Touch TIMER/SETTINGS pad.
5. Touch the number pads to enter
cooking time. Touch POWER LEVEL
pad repeatedly until the desired power
level is reached.
6. Touch START/+30 SEC pad.
Demonstration Mode
To select Demo Mode
x 7 1. Touch TIMER/SETTINGS pad 7 times.
2. Hold START/+30 SEC pad for 3
seconds. The display shows: DEMO
ON.
To cancel Demo Mode
x 7 1. Touch TIMER/SETTINGS pad 7 times.
2. Touch START/+30 SEC pad. The
display shows: DEMO OFF.
NOTE:
• Microwave doesn't heat in Demo Mode.
• Display counts down quickly.
Standby Mode
This microwave will go into standby mode after a period
of inactivity. The backlight of the display will automatically
dim after 3 minutes if the unit has not been in operation.
If the display is in standby mode, simply touch the control
panel or OPEN/CLOSE the door to return the backlight to
maximum brightness.
EN
15