Publicité
Les langues disponibles
Les langues disponibles
GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1
MRA-Windshield
2
Cross-recessed screw M5x30
2
Collar black M6
2
Spacer 10mm
1
Edge protection strip with sleeves
Fitting the screen to the motorcycle:
1. Place the motorcycle on a flat surface.
2. Remove the mirror.
3. Remove the covers (P1).
4. Remove the screws (P2).
5. Draw the fairing carefully from the locking mechanism (P3).
6. Lift the tips of the fairing (P4).
7. Push the fairing panel slightly forward, away from the locking mechanism (P4).
8. Remove the fairing panel taking it out to the rear (P4).
9. Remove the black Allen screws from the cockpit shield (P5).
10. Take the MRA windshield, put the supplied collars onto the supplied cross-recessed screws and then
put the screws into the holes in the windshield.
Put the supplied spacers onto the cross-recessed screws. The screws must not stick out at the end
side in order to prevent scratching of the shield (P6).
11. Slide the shield into the fairing from the rear and slightly fasten the cross-recessed screws. Scheibe
richtig in der Verkleidung fixieren.Fasten the shield properly in the fairing.
12. Carefully lock the fairing into place (P4).
13. Fasten the screws of the fairing (silver Allen screws) (P2). Important! Make sure to not mix up the
Allen screws as they have different shank diameters.
14. Fasten the cross-recessed screws (P4).
15. Fit and fasten the covers (P1).
16. Fit the mirror.
17. Apply the edge guard profile to the exposed rear area of the windshield, starting at the fairing
transition and ending at the opposite side. Cut off the rest if required
18. It is also possible to push the clamping sleeves over the ends of the protective edge strip and lightly
compress these using a pair of pliers to secure the edge strip.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
Honda CBR600F 2011-
Article No..
---
Inbus 5mm
Phillips screwdriver size 2
10693
10679
10688
---
3
Required tools
Publicité
