Use; Salt, Rinse-Aid And Detergent - Pelgrim GVW710ONY Notice D'utilisation

Salt, rinse-aid and detergent

Salt
Only use regenerating salt for dishwashers.
Under no circumstances use table salt!
It is quite normal that water bubbles up out of
the reservoir when it is being filled with salt.
Unscrew the cap of the salt container in an
anticlockwise direction. Place the supplied
funnel on the container (see Fig. 3). Before
using the dishwasher for the first time,
pour one litre of water into the container
and then pour 1.5 kg of salt into the
container. Carefully remove any spilt salt
and screw the cap on again.
Only fill the salt container before operating
a programme. Regenerating salt is
corrosive and can damage the interior of
the dishwasher.
The right amount of salt
The dishwashers "B" and "C" are equipped
with a salt indicator. The indicator lamp
comes on when the salt container needs
refilling.
Dishwasher "A" does not have a salt
setting.
Refill the salt reservoir after every
20 cycles.
Dishwasher "B" and "C"
The dishwasher can be adjusted to the
correct quantity of regenerating salt,
depending on the hardness of the tap
water.
Measure the hardness of the water with
Fig. 3
the test strip provided. Adjust the salt use
in accordance with the colour of the strip.
Make the adjustment by adjusting the
catch in the salt refill opening in
combination with the control pin in the door
frame.
There are four different adjustments
possible:
test strip- hard- doorjamb
colouring ness slide
°dH
none* < 3 no salt
1 zone red > 4 up
2 zones red > 7 up
3 zones red >14 down
4 zones red >21 down
* fill once a year
Please note:
The dishwasher has been adjusted to the
maximum position.
salt
reservoir
pawl
no salt
left
right
left
right