Mounting - Pelgrim GVW710ONY Notice D'utilisation

Mounting

Installing door panel (see Fig. 9)
First determine the height of the control
panel.
Place the template on the inside of the door
panel.
The measuring marks correspond to the
measured height of the panel.
Centre the template on the right and left
sides with the aid of the measuring marks.
Transfer the markings of the drill holes on
the template onto the door.
If the door panel is made of solid wood,
predrill the holes with a 2 mm drill (12 mm
deep).
Note:
Allow for possible differences in the thickness
of the panel (milled hollows or bevelled
edges).
Fix the mounting material to the door, with
the plastic parts at the top and the metal
parts at the bottom (see Fig. 10).
Fig. 9
Attach the panel to the door of the
dishwasher by pressing the upper pins into
the slots of the plastic section.
Slide the panel up a little so that the bottom
hooks drop into the intended slots
Fasten the bottom hooks from the front with
M5 screws.
Fig. 10