Pelgrim GVW710ONY Notice D'utilisation page 39

Adjusting the spring tension (see Fig. 11)
A
As standard setting, the door is adjusted to
the lowest spring tension.
Increase the tension of the spring by
turning the two adjusting screws (A) in a
clockwise direction with a screwdriver.
The tension of the spring is correct if the
door is in a state of equilibrium when open.
Positioning (see Fig. 12)
Note:
You should not allow the hoses to develop
kinks or get flattened during the installation of
the dishwasher in the recess.
Mount the metal plate provided to the
underside of the unit top, moisture could
damage the unit top.
Adjust the dishwasher so that it is level.
Mount the dishwasher to the unit top.
Mount the plinth in place.
Carefully open the dishwasher to check
whether or not the door hits the plinth.
Fig. 11
If this is the case, mark the part of the
skirting-board to be removed.
Leave a free space of three millimetres
between the door and the skirting-board so
that the door can open and close freely.
Make the sawn-off piece of skirting-board
waterproof – with paint, for example – and
replace the skirting-board.
What else you should watch out for
Do not make the free space around the
appliance larger than three millimetres. If
there is more free space, there is the risk of
contact with electrical components of the
appliance.
Water outlet
The outlet must be fitted with an odour-
trap.
Fig. 12
The drainage hose must hang free inside
the outlet. The outlet may not be sealed off.