General Instructions - Starmix Quadrix L 18 V Notice D'utilisation

6.2 PressClean
To clean the pleated filter (16) using a strong
air flow: Put the rotary switch (14) in BOOST
position, cover connecting sleeve (21) or
suction opening (10) with the hand and
press the button (11) several times (at least
3 times).
7. Use
7.1 Dry Vacuuming
WARNING - This device is only intended for
dry use.
Vacuum only with dry pleated filter (16),
device and accessories. If the cartridge is
damp, dust may stick and form a crust.
The device must not be switched on without
pleated filter in place (16).
7.2 Transport
Remove suction hose (22) fromt he suction
opening (10) and store in housing according
to fig. C on page 2. In start position 1 Insert
hose end and wind the hose in the housing
around the vacuum cleaner in clockwise
direction.
The upper part (7) must be securely sealed
to the dust container (1) - check that the
snap locks (2) are closed.
Put rotary switch (14) in "OFF" position
(transport lock).
Store spare battery pack (24) according to
figure B on page 4. Push open downwards
along the ridges (direction of arrow).
Store charger (23) according to figure B on
page 4. Push into the charger storage along
the ridges (direction of arrow).
8. Cleaning
8.1 General Cleaning Instructions
Clean the dust container (1) and accessories
with water. Wipe the upper part (7) with a
damp cloth.
Caution! This device contains dust that is
harmful to health. Discharge and mainte-
nance operations (including disposal of the
dust collection containers) must only be
carried out by qualified specialists wearing
appropriate protective clothing and equip-
ment.
Emptying the Container
Only permitted for dusts with occupa-
tional exposure limits > 1 mg/m
- Put rotary switch (14) in "OFF" position.
- Remove battery pack (8).
- Open the snap locks (2). Remove the upper
part (7) of the device from the dust
container (1).
- Tip out the container.
Disposing of the Fleece Filter Bag
- Put rotary switch (14) in "OFF" position.
- Remove battery pack (8).
- Open the snap locks (2). Remove the upper
part (7) of the device from the container
(1).
- Fold down the carry handle of the dust
container (unlock).
- Carefully remove the fleece filter bag (18)
and close the fleece filter bag using the
drawstrings.
- Dispose of the vacuumed material in
accordance with legal regulations.
Clean the pleated filter via PressClean
- Clean the pleated filter according to
chapter 6.2.
Clean the pleated filter manually
- Remove the pleated filter according to
chapter 9.2.
- Occasionally tap the pleated filter to
remove (16) any dust that has gathered on
it. If the filter is very dirty, you can clean it
with water (max. 3x, then insert new
pleated filter) and a soft brush. Allow to
filter to dry properly afterwards.
9. Maintenance

9.1 General instructions

Before performing any maintenance,
always switch off the device and
remove the mains plug.
Clean the device (see chapter 8.).
For maintenance by the user, the vacuum
cleaner must be taken apart, cleaned and
ENGLISH en
3
.
17