Self-Diagnosis; Cleaning And Maintenance; Fault Check List - Tristar AC-5498 Mode D'emploi

• When the machine is in Sleeping function, the Fan Speed would
turn to be LOW speed.

Self-diAgnoSiS

This machine is equipped with self-diagnosis function. If something is
wrong in the machine, the LED will show the word "E1" or "E2". As this
time, please call your service centre.
effiCienCy BooSting
This unit is equipped with "energy efficiency boosting" function, by
adding the water to the water tank as below, the energy efficiency can
be elevated greatly, save energy for the earth, save money for you.
1. Open the door for the water tank
2. Take out the water tank
3. Unscrew the tap for the tap for the tank and fill up the tank with
clean water
notiCe
• To prolong the compressor's life, after switch-off of the unit, please
wait for 3 minutes (at least) before re-switch.
• The cooling system will switch off if the ambient temperature is
lower than the set one. The ventilation, however, keeps working on
the set level. If the ambient temperature rises above the selected
level, the cooling will return to work.

CleAning And mAintenAnCe

• Always remove the plug from the socket when the device is cleaned.
• Clean the outside with a damp cloth. Never use harsh and abrasive
cleaners, steel wool or a scouring pad as this will damage the
device. Do not immerse in water or other liquid.
• Remove filters from the device and clean it with warm soapy
water, let the filters dry completely before being replaced. Turn the
appliance without filters. If the unit is stored after the season, drain
the condensate water and put the cord on the cord storage area.

fAult CheCK liSt

the Air Conditioner doeS not run
Is the air conditioner plugged in?
Is there a power failure?
Is the comp / 'full water' indicator flashing?
Is the room temperature below the set temperature?
the mAChine SeemS to do little
Is there direct sunshine ? (Please put down the curtain.)
Are too many windows or doors open?
Instruction manual
AC-5498
EN
9