Tristar AC-5498 Mode D'emploi page 7

• During cooling of hot air condenswater will be created. Much of the
condensation will be transported with the warm air to outside. At
high humidity not all the condense will be transported with the warm
air to the outside, the water tank must regularly be emptied.
• In the chapter "Condensate Drain" is this defined step by step.
• There are several ways to transport warm air out of the room:
• Attach the hose in the warm air outlet of the device. Hang the hose
out the window or a door. The cooling capacity will not be optimal
because of warm outside air will flow into the to cool area.
• Place the window spacer in the open section of the window. Insert
the hose into the connection for the hose. The cool capacity is
optimal. Provide a maximum distance of 36 cm. the device to the
windows or exterior wall.
• Drill a hole of 152 mm. diameter in the outer wall and enter the
tubing through the hole. The cool capacity is now optimal. Place the
wall cover on the outside of the wall. When the appliance is out of
use, the cover can be placed on the hole.
• Make sure that the hose is not kinked or that the air flow is obstructed.
• Never extend the hose.
drAinAge
• During cooling of hot air, condensation can be created. Much of the
condensation will be transported with the warm air outside. At high
humidity not all the condense will be transported with the warm air
to the outside, the water tank must regularly be emptied.
• If the condensation tank is full, the water full indicator light on the control
panel will light and a sound goes off, the machine stops automatically.
The condensate tank has a maximum capacity of 1.7 liter.
Instruction manual
AC-5498
EN
7