Service & Maintenance; Clean The Ascender; Clean The Charging Pins; Changing The Primary Connection Sling - ActSafe T1-16 Manuel Utilisateur

SERVICE & MAINTENANCE
SERvICE & MAInTEnAnCE
Use only original spare parts / material
recommended by ActSafe Systems AB.
Clean the unit regularly. Check the char-
ging pins and karabiners for oxidation.
Clean and lubricate if needed.

Clean the charging pins

1. Remove the charging cap.
2. Spray the pins with a multi purpose
lubricant such as "CRC 5-56" or similar.

Changing the primary connection sling

If unsure of any of these steps, contact
ActSafe Systems AB or local distributor.
1. Unscrew the screw holding the sling.
2. Pull out screw, the sling will come loose.
3. Assemble new sling on the screw.
4. Tighten the screw to 10 Nm.
Use Loctite 542!
30
RECOMMENDATION
Go through "Checklist before and after usage"
at every maintenance to increase the safety for
the user/users of the ascender.

Clean the ascender

Never use a high-pressure washer, this
may cause damage to the ascender.
Rinse the ascender with water, wipe
with a wet cloth and let it dry.
Clean the karabiner thoroughly,
lubricate with thin oil.
© Copyright ActSafe Systems AB