Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

SYSTEM DESCRIPTION

Charger

When the battery is at room temperature
the charging time is approximately 45
minutes. If the ascender has been used
recently the charging time will be longer,
since the internal battery temperature is
higher and the charger can't work at full
effect.
When tested at ActSafe the longest time
for recharge due to very high battery tem-
perature is 3h.
When the charger is connected the
ascender will switch into charging mode,
where operation is not possible.
Over load and heat monitoring and protection
The ascender is well designed for strenuous
work with loads up to 150 kg. The risk of
over heating is slim.
The load is monitored electronically and
if the load exceeds approximately 180 kg,
the motor is switched off.
The internal temperature of the ascender is
monitored continuously and performance
(lift speed) is limited if there is a risk of over
heating.
18
Other battery chargers may damage the
battery and may cause development of
toxic gases or in a worst-case cause an
explosion.
CAUTION
Only use in combination with ActSafe
original battery charger.
RECOMMENDATION
The charging time with elevated battery
temperature can be decreased by cooling the
ascender while being connected to the charger.
If over heated the ascender must cool down
before it comes operable again. The time
for cool down is dependent on the ambient
temperature.
© Copyright ActSafe Systems AB

Publicité

Chapitres

Table des Matières
loading

Produits Connexes pour ActSafe T1-16

Table des Matières