Control Panel - ActSafe T1-16 Manuel Utilisateur

SYSTEM DESCRIPTION
1
General
This ascender has been designed for lifting/
lowering a person or load in a static rope
system (including backup rope), with ropes
of 10-13mm approved by EN1891. The
dead rope shall be unloaded.
The karabiner in the primary connection
can be replaced by any other karabiner
approved by EN362. The sling in the chassis
cannot be replaced, by anything other than
an original spare part from ActSafe Systems
AB.
The ascender is equipped with a Schra-
der valve. It allows leakage/tightness test
equipment to be connected during inspec-
tion. ActSafe can offer equipment as well as
training for service personnel.
12
2
3
NO PART
1 Loop (Rope guide)
2 Knife
3 Rope cover
4
4 Rope grab with heat protection shield

Control panel

All buttons are equipped with LEDs that
indicate the travel mode that is active.
If the ascender is switched off when
the LEDS are deactivated, the LEDS will be
deactivated when it is switched on the next
time.
1
NO PART
1 Battery indicator
2 Lights on/off button (press 3 sec)
3 Down button
4 Up button
5 Power button
Always light the control panel before shutdown
to avoid confusion when starting the ascender.
2 3 4
RECOMMENDATION
5
© Copyright ActSafe Systems AB