Identify The Vent Location; Cut To Fit - ubbink Rolux Vent system condensation Instructions Pour L'installation

Installation Instructions
¨
Rolux Vertical Condensing Discharge Vent System
1

Identify the vent location

NOTE
Cover the top of the appliance
Cover the top of the heater
to prevent debris from entering.
to prevent debris from entering.
2

Cut to fit

A
13
Determine the location where the roof
discharge terminal will be installed. Taking
into account the angle of the roof, cut the
hole with a dimension that allows the
vertical discharge roof terminal to be
installed (6"x6" hole for flat roof, 9"x6" hole
for 12/12 pitch, or 12"x6" hole for 16/12
pitch).
The terminal can be
shortened by cutting
both the inside and
outside pipes with
the same length X.
Deburr the sharp edges,
other wise the gaskets might
get damaged, which can
result in the system no longer
being air tight.
B