Technical Data - LaserLiner SuperCross-Laser SCL 3 Mode D'emploi

Horizontal and vertical levelling:
Open the battery compartment (2) and insert batteries according to the symbols. Correct polarity
must be observed. Release the transport restraint, put the ON/OFF switch (4) into its right position
("ON" ). Now the tilt function is active and the indicator LED (11) will light up green if the device is
set up correctly. The desired laser lines can be selected with the selection button (5). The indicator
LED (11) will light up red if the device is tilted too much, such that the pendulum is out of its self-
levelling range. There will also be a warning sound and the lasers will blink. The unit must then be
placed on a surface which is closer to level. Refer to the application examples in Figures A, B, C on
page 2.
Slope mode:
Do not release the transport restraint, put the ON/OFF switch into its left position ("OFF"). Now the
tilt function is inactive! Select and switch on the laser with the selection button (5). Now the indica-
tor LED (11) will light up red and the device can be placed on sloped or tilted surfaces. Refer to the
application example in Figure D on page 2. IMPORTANT: This mode cannot be used to perform
horizontal or vertical levelling because the laser lines are no longer automatically aligned.

Technical Data

Automatic levelling range
Accuracy
Operating range (depending on room illumination)
Laser wavelength
Laser class / line laser output power
Power supply
Dimensions / weight (without wall bracket and batteries)
Temperature range, operating / storage
Order number
Subject to technical changes without notice
Note: Regularly check the calibration before use, after transport and after extended periods of
storage.
ENGLISH
SuperCross-Laser SCL 3
± 5°
± 5 mm / 10 m
20 m
635 nm
2M / < 5 mW
4 x 1,5V AA / ca. 20 h
122 x 100 x 70 mm / 0,55 kg
0°C ... +50°C / -10°C ... +70°C
081.140A
04/2009
9