Technical Data - LaserLiner SmartCross-Laser Mode D'emploi

3 Slope mode
Do not release the transport restraint, set the ON/OFF switch to „OFF". Select and switch
on the laser with the selection button. Sloping planes can now be measured. This mode
cannot be used to perform horizontal or vertical levelling as the laser lines are no longer
aligned automatically. The LED lights constantly red.
LASER LASER

Technical data

Self-levelling range
Accuracy
Operating range
(depending on room illumination)
Laser wavelength
Laser class / line laser output power
Power supply
Operating time
Operating temperature
Storage temperature
Dimensions (W x H x D)
Weight (incl. batteries)
Guarantee, product care and disposal
This device complies with all necessary standards
for the free movement of goods within the EU.
This product is an electric device and must be collected separately
for disposal according to the European Directive on waste electrical
and electronic equipment.
Further safety and supplementary notices at:
www.laserliner.com/info
Preparing the calibration check
It is possible for you to check the calibration of the laser. To do this, position the device
midway between 2 walls, which must be at least 5 metres apart. Switch the device on
(LASER CROSS ON). The best calibration results are achieved if the device is mounted
on a tripod.
1. Mark point A1 on the wall.
2. Turn the device through 180° and mark point A2. You now have a horizontal
reference between points A1 and A2.
1.
A1
2.
Performing the calibration check
3. Position the device as near as possible to the wall at the height of point A1.
4. Turn the device through 180° and mark point A3. The
difference between points A2 and A3 is the tolerance.
3.
A1
4.
If points A2 and A3 are more than 0,5 mm / m, the device is in need of
!
calibration. Contact your authorised dealer or else the UMAREX-LASERLINER
Service Department.
6 GB
LASER LASER
A2
A3
Subject to technical alterations. 02.13
± 5°
± 0.5 mm / m
10 m
650 nm
2 / < 1 mW
2 x 1.5V alkaline batteries
(type AA, LR6)
15 hours (alkaline batteries)
0 °C ... +40 °C
-10 °C ... +70 °C
55 x 85 x 75 mm
260 g
A2
A2
A2
A3