Horizon Hobby HANGAR 9 Ultra Stick 10cc Manuel D'utilisation page 20

79. Check to make sure you can install the hinges and joiner
wire. The leading edge of the elevator will fi t tightly
against the trailing edge of the stabilizer.
80. Mix a small amount of 15-minute epoxy. Use a toothpick
to apply epoxy to the joiner wire.
81. Use a toothpick to apply epoxy to the stabilizer where it
contacts the joiner wire.
82. Fit the elevator back into position. Remove the T-pins
and slide the elevator tightly against the stabilizer. Use a
paper towel and isopropyl alcohol to remove any excess
epoxy before it begins to cure. Use low-tack tape to hold
the elevator tightly against the stabilizer.
 The remaining elevator can be
installed while the epoxy cures.
83. Apply epoxy to the exposed joiner wire.
EN
79.
80.
81.
82.
83.
84. Use a toothpick to apply epoxy to the stabilizer where it
contacts the joiner wire.
85. Fit the remaining elevator into position. Slide it tightly
against the stabilizer, then use low-tack tape to hold it
in position until the epoxy fully cures. Once the epoxy
has cured, remove all tape and clear plastic from the
stabilizer.

Do not use CA accelerator when gluing hinges. The
CA must be allowed to soak into each hinge to provide the
greatest bond between the hinges and surrounding wood.
86. Remove the T-pins from the hinges. Flex the elevator
slightly, making sure to keep the gap between the
elevator and stabilizer as narrow as possible. Saturate
each of the hinges using thin CA. Apply CA to the top and
bottom of the hinges.
87. Gently pull on the fi xed and moving surface to make sure
the hinges are glued securely. If not, reapply thin CA to
any hinges that are found loose. Flex the control surface
through its range of motion a few times to break-in the
hinges. This will reduce the initial load on the servo when
the surface is fi rst actuated.
 RUDDER AND TAIL WHEEL INSTALLATION
88. Slide the tail wheel bracket on the tail wheel wire. Use a
1.5mm hex wrench to loosen the setscrews in the wheel
collar for the tail wheel. Slide the wheel collar as close to
the tail wheel as possible.
20
84.
85.
86.
87.
88.