Step 4: Installing Anti-Tip Device - Thermador P30 Instructions D'installation

Masquer les pouces Voir aussi pour P30:

Manuel d'utilisation et d'entretien (80 pages)

Table des Matières

Les langues disponibles

For all 30" and 36" ranges, an anti-tip device must be installed as per these

instructions.

RANGE TIPPING HAZARD

•

All ranges can tip and injury can result.

To prevent accidental tipping of the range,

attach it to the floor, wall or cabinet by

installing the Anti-Tip Device supplied.

•

A risk of tip-over may exist if the appli-

ance is not installed in accordance with

these instructions.

•

If the range is pulled away from the wall

for cleaning, service or any other reason,

ensure that the Anti-Tip Device is prop-

erly reengaged when the range is pushed

back against the wall. In the event of

abnormal usage (such as a person stand-

ing, sitting, or leaning on an open door),

failure to take this precaution can result

in tipping of the range. Personal injury

might result from spilled hot liquids or

from the range itself.

ELECTRICAL SHOCK HAZARD

•

Use extreme caution when drilling holes

into the wall or floor. There may be con-

cealed electrical wires located behind the

wall or under the floor.

•

Identify the electrical circuits that could

be affected by the installation of the Anti-

Tip Device, then turn off power to these

circuits.

•

Failure to follow these instructions may

result in electrical shock or other per-

sonal injury.

Tools Needed for Installation of Anti-Tip Device:

• Screwdriver, Phillips

• Drill, electric or hand

• Measuring tape or ruler

• 1/8" drill bit (wood or metal wall or floor)

• 3/16" carbide-tipped masonry drill bit (concrete or concrete block wall or floor)

• 3/16" anchors, drywall or concrete, 4 each (not required if mounting bracket is being attached to solid wood or metal)