Preparation; Installation Procedure; Checklist; Step 1 - Convert The Pressure Regulator - Thermador SNLPKITF Manuel D'installation

Preparation

Preparation
CAUTION
TURN OFF GAS AND ELECTRICITY.
Before proceeding with the conversion, 1) shut off
the gas valve for the gas supply line to the cooktop,
2) remove the cooktop power cord from the
electrical outlet or turn off the breaker at the breaker
box, and 3) turn all control knobs to the "Off"position.
Installation Kit Contents
Qty Item
1 Installation Manual
1 Label sticker - "Unit Converted for Use with LP Gas''
1 Foam Tape
Venturis
2 9mm
1 10.5 mm
2 12.5 mm
Orifices
2 #74
2 #91
1 #117
Depending on the model (some are 4 burner models,
some are 5 burner) the kit may contain more venturis and
orifices than are necessary to complete your appliance
conversion.
Tools Required
20mm socket
(and driver or ratchet)
3
7mm socket driver
(3" min. extension)
flat blade screwdriver

Installation Procedure

This conversion process adjusts the flow of gas to the
burners to accommodate an LP gas fuel source.

Checklist

Each of the following steps must be completed
correctly for the appliance to function properly.
Check off each step as it is finished.
__ Step 1 - Convert the pressure regulator to use LP gas.
__ Step 2 - Remove the Natural Gas (NG) venturis and
orifices and replace them with the LP gas venturis and
orifices supplied with this kit.
__ Step 3 - Adjust the unit valves to LP settings.

Step 1 - Convert the Pressure Regulator

Locate the pressure regulator on the bottom right end of
the cooktop.
Note: The arrow on the back of the regulator must
point in the direction of the gas flow to the
cooktop.
.