Error Messages - Sony STR-DA2800ES Mode D'emploi

Error messages

You can check the status of the receiver by the
message. See the following to solve the
problem. If any problem persists, consult your
nearest Sony dealer.
PROTECTOR
The receiver is covered and ventilation holes
are blocked. The receiver will automatically
turn off after a few seconds. Remove the
object covering the upper panel of the
receiver and turn on the power again.
FAN STOPPED
Check that the ventilation hole on the top of
the receiver is not blocked.
"A new software version is available.
Please go to the "Setup" section of the
menu and select "Network Update" to
perform the update." appears on the TV
screen.
See "Network Update" (page 111) to update
the receiver to a newer software version.
Video cannot be output from this jack.
• If you use the receiver in the main zone,
connect the receiver to a TV via an HDMI
cable.
• If you connect the receiver to a TV via a
video cord, set "Playback Resolution" to
"480i/576i" (page 102).
• If you connect the receiver to a TV via a
component video cord, set "Playback
Resolution" to a parameter appropriate to
your TV (page 102).
130
US