Sony STR-DA2800ES Mode D'emploi page 45

• If you connect a subwoofer with an auto
standby function, set it to off (deactivated).
Notes
• Depending on the characteristics of the subwoofer
you are using, the setup distance value may be
different from the actual position.
• If you perform "Speaker Settings (Auto
Calibration)" using the Easy Setup, the
measurement results will be overwritten and saved
on the currently selected position ("Pos.1" is
selected as the factory default setting).
Tips
• Depending on the position of the subwoofer, the
measurement results for polarity may vary.
However, there will be no problems even if you
continue to use the receiver with that value.
• Depending on the speakers, "Out Phase" may
appear even if there is no problem with the speaker
connection. This is caused by the speaker
specifications, and there will no problems even if
you continue to use the speakers.
When you connect two
subwoofers to the receiver
If you cannot obtain measurement results of
the "Auto Calibration" function correctly,
depending on the environment, or you want to
make fine adjustments, you can set up the
subwoofers manually. For details, see
"Speaker Setup" in the Speaker Settings menu
(page 95).
Notes on the speaker
impedance
• If you are not sure of the impedances of the
speakers, refer to the operating instructions
supplied with your speakers. (This
information is often on the back of the
speaker.)
• When you connect front speakers to both the
FRONT A and SURROUND BACK/
FRONT HIGH/FRONT B/ZONE 2
terminals, connect the speakers with a
nominal impedance of 8 ohms or higher.
To select the front speakers
You can select the front speakers you want to
drive.
SPEAKERS (OFF/A/B/A+B)
Press SPEAKERS (OFF/A/B/A+B)
repeatedly to select the front speaker
system you want to drive.
You can confirm which set of terminals (A or
B) are selected by checking the indicators in
the display window.
Indicators Selected speakers
SP A The speakers connected to the
FRONT A terminals.
SP B The speakers connected to the
SURROUND BACK/FRONT
HIGH/FRONT B/ZONE 2 terminals.
SP AB The speakers connected to both the
FRONT A and SURROUND BACK/
FRONT HIGH/FRONT B/ZONE 2
terminals (parallel connection).
"SPEAKERS OFF" appears in the
display window.
No audio signals are output from any
speaker terminals.
Note
To select a front B speakers, you should set the
assignment for the SURROUND BACK/
FRONT HIGH/FRONT B/ZONE 2 terminals
by using the "Speaker Connection" of the
Speaker Settings menu.
continued
45 US