Speaker Connection - Sony STR-DA2800ES Mode D'emploi

Select the "Position" for which you want to
register the measurement results on the
Auto Calibration Setup screen.
• Pos.1
• Pos.2
• Pos.3
To set a compensation type for the
speakers
You can select the compensation type to be
used for the speakers for each Position.
1
Select the "Position" for which you want
to set the speaker compensation type,
then press .
2
Select the "Calibration Type" you want,
then press .
• Full Flat
Makes the measurement of frequency
from each speaker flat.
• Engineer
Sets the frequency to match that of the
Sony listening room standard.
• Front Reference
Adjusts the characteristics of all the
speakers to match the characteristics of
the front speakers.
• Off
Sets the Auto Calibration EQ to off.
Note
You cannot set the "Calibration Type" for "Position"
for which the measurement results have not been
registered.
To name the Position
1
Select the "Position" for which you want
to name, then press
2
Select "Name In," then press
The soft keyboard appears on the screen.
3
Press V/v/B/b and
character one by one.
94
US
.
.
to select a
Automatic Phase Matching
Lets you set the A.P.M. (Automatic Phase
Matching) function in the D.C.A.C. (Digital
Cinema Auto Calibration) function (page 93).
Calibrates the phase characteristics of the
speakers and ensures a well-coordinated
surround space.
x Off
Does not activate the A.P.M. function.
x Auto
Switches the A.P.M. function on or off
automatically.
Notes
• This function does not work in the following cases.
– "2ch Analog Direct" is being used.
– Headphones are connected.
– "Auto Calibration" has not been performed.
• The receiver may play back signals at a lower
sampling frequency than the actual sampling
frequency of the input signals, depending on the
audio format.

Speaker Connection

Lets you adjust each speaker manually. You
can also adjust the speaker levels after Easy
Setup is completed.
The Speaker Settings are only for the current
"Position."
You can make the following settings using the
wizard.
Speaker Pattern
Lets you select the speaker pattern for the
speaker systems you are using.
Surround Back Assign
Lets you set the SURROUND BACK/FRONT
HIGH/FRONT B/ZONE 2 terminals for a bi-
amplifier or a zone 2 connection.
x Zone2 Speakers
x Bi-Amplifier