Messages - Sony DSX-A410BT Mode D'emploi

Cannot pair.
 The unit may not be able to pair with a previously
paired BLUETOOTH device after initializing the
unit if the pairing information of the unit is on the
BLUETOOTH device. In this case, delete the
pairing information of the unit from the
BLUETOOTH device, and then pair them again.
BLUETOOTH function cannot operate.
 Turn off the unit by pressing OFF for more than
2 seconds, then turn the unit on again.
No sound is output from the car speakers during
handsfree call.
 If the sound is output from the cellular phone, set
the cellular phone to output the sound from the
car speakers.
Siri Eyes Free is not activated.
 Perform the handsfree registration for an iPhone
that supports Siri Eyes Free.
 Set the Siri function on the iPhone to on.
 Cancel the BLUETOOTH connection with the
iPhone and the unit, and reconnect.
Sony | Music Center operation
Application name is mismatched with the actual
application in "Sony | Music Center".
 Launch the application again from the "Sony |
Music Center" application.
While running the "Sony | Music Center"
application via BLUETOOTH, the display
automatically switches to [BT AUDIO].
 The "Sony | Music Center" application or
BLUETOOTH function has failed.
 Run the application again.
The "Sony | Music Center" application is
automatically disconnected when the display
switches to [IPOD].
 The "Sony | Music Center" application on iPhone/
iPod does not support iPod playback.
 Change the source of the unit to other than
[IPOD], then establish the "Sony | Music
Center" connection (page 17).
The "Sony | Music Center" connection is
automatically disconnected when the USB mode
of the unit is changed to [ANDROID].
 The Android smartphone is not supporting
playback in Android mode.
 Set the USB mode of the unit to [MSC/MTP],
then establish the "Sony | Music Center"
connection (page 17).

Messages

The following messages may appear or flash during
operation.
INVALID
 The selected operation could be invalid.
 [USB MODE] cannot be changed during iPod
playback.
READ: Now reading information.
 Wait until reading is complete and playback
starts automatically. This may take some time
depending on the file organization.
(underscore): The character cannot be
displayed.
For USB device playback:
HUB NO SUPRT: USB hubs are not supported.
IPD STOP: iPod playback has finished.
 Operate your iPod/iPhone to start playback.
NOT SUPPORT - ANDROID MODE
 A USB device not supporting AOA (Android Open
Accessory) 2.0 is connected to the unit while [USB
MODE] is set to [ANDROID].
 Set [USB MODE] to [MSC/MTP] (page 20).
USB ERROR: The USB device cannot be played.
 Connect the USB device again.
USB NO DEV: A USB device is not connected or
recognized.
 Make sure the USB device or USB cable is securely
connected.
29
GB