Sony STR-DA2800ES Mode D'emploi page 121

you may not be able to record from the
sources.
• Set "Auto Standby" to "Off" (page 110).
While only composite video signals are
being recorded, the auto standby function
of the receiver may start up and interrupt
the recording.
Specific type of image is not output or
corrupted.
Component video output
• The resolution of output signals from the
COMPONENT VIDEO OUT jacks may
not be supported by your TV. In this case,
select the appropriate resolution on the
receiver (page 100).
• COMPONENT VIDEO MONITOR OUT
jacks have restrictions on resolution when
the resolution of video signals protected
by copyright technology is converted. The
resolution of the signals output to the
COMPONENT VIDEO MONITOR OUT
jacks is converted up to 480p/576p.
HDMI output
• The output of the HDMI video signals of
the receiver may be set to "OFF." In this
case, select "HDMI A" or "HDMI B"
using the HDMI OUTPUT button
(page 81).
• When "Zone2 Out" is set to "Off," no
signals from HDMI ZONE 2 will be
output.
• GUI and upconverted video signals will
not be output from the HDMI ZONE 2
OUT jack.
• The audio and video signals of the HDMI
IN jacks will not be output from the HDMI
ZONE 2 OUT jack when the same input is
selected for both the main zone and zone 2
and the GUI menu is displayed on the TV
in the main zone.
• When the Zone2 Out function is enabled
and you select the same HDMI input for
both the main zone and zone 2, there may
be some interference on the audio and
video signals in the main zone and zone 2.
To avoid possible interference in the main
zone, you can place priority on the main
zone for HDMI input selection (page 76).
• Be sure to use a connecting cable for the
HDMI jack corresponding to a High Speed
HDMI cable when you want to view
images or listen to sound, especially for
1080p, Deep Color, or 3D or 4K
transmissions.
4K image
• Depending on the TV or video equipment,
4K images may not be displayed. Check
the video capability and setting of your TV
or video device. Also, make sure to
connect the video equipment to an
available 4K HDMI IN jack of the
receiver.
3D image
• Depending on the TV or the video
equipment, 3D images may not be
displayed. Check the 3D image formats
supported by the receiver (page 134).
VCR
• If you use a VCR without an image
improvement circuit, such as TBC, the
images may be distorted.
When you select "My Video," "My
Music," "My Photo," "Internet Video,"
"Internet Music," "Network," or "Sony
Entertainment Network" from the
Watch/Listen menu, no picture is
output.
• Select "BD" or "DVD" using INPUT
SELECTOR on the receiver once, then set
"Playback Resolution" to "480i/576i" or
"480p/576p"in the Video Settings menu
using the GUI (page 102), and select the
content again.
continued
121 US