MAAX 137240 Guide D'installation page 8

4 - SECURE THE STATIONARY PANELS AND THE STRUCTURE 4 -
1
Wide side toward
glass panel
Working inside the shower cabin, install the window tabs, as
indicated on the right hand figure.
Install from the bottom of the glass panel the tab [sic]. If necessary,
use a flat and dull tool (paint mixer, for example) to push the tab
between the glass panel and the panel post GROOVE.
In order to properly install the tab, be careful that its wider side
point toward the glass panel. Cut excess length at the top.
Repeat the procedure for the other side.
2
View from inside
of shower cabin
Make sure that the shower cabin is centered over the base
threshold.
Make sure that the rail is laying flat and evenly on the base and
perform any necessary adjustment.
Tighten fully the wall post lower face screws to secure the
structure in place, as indicated on the figure.
8
View from inside
of shower cabin
x2
View from inside
of shower cabin