Reversing The Door - Signature SDP3101A+ Instructions D'utilisation

11. REVERSING THE DOOR

The side at which the door opens can be changed from the right side (as supplied)
to the left side, if the installation site requires.
Before you start lay the refrigerator on it's back in order to gain access to the base,
you should rest it on soft foam packaging or similar material to avoid damaging
the cooling pipes at the rear of the refrigerator.
1. Stand the refrigerator, use a flat
bladed screw driver to remove the
4 screw covers at the rear of the
refrigerator lid.
2. Unscrew and lift the lid from the
rear and remove it, then lift the
upper door and place it on a
padded surface to prevent it
scratched.
3. Remove the upper hinge core,
transfer it to left side and tighten
securely, then put it in a safe place.
4. Remove the two flange screw,
then remove the middle hinge that
hold the lower door in place. Lift the
lower door and place it on a padded
surface to prevent scratching it.
5. Remove the hinge hole cover from
the right holes as illustrated and transfer
them to the uncover hole at the left side.
6. Remove both adjustable feet and
remove the bottom hinge bracket
by unscrewing the bolts.
7. Unscrew and remove the bottom
hinge pin, turn the bracket over and
replace it. Refit the bracket fitting the
bottom hinge pin. Replace both
adjustable feet. Transfer the lower
door to the property position. Secure
the door's level, make the bottom
hinge pin into the lower hole of the
door, then tight the bolts.
6